TASCAM’s compact DR-10X attaches to a handheld microphone for the ultimate compact news gathering recording system. A captive XLR connector attaches firmly to your microphone, capturing interviews at 48kHz/24-bit Broadcast WAV resolution. Offload recordings through the microUSB connection or by removing the microSD card.
The DR-10X has both manual and automatic gain settings, with a low cut filter and limiter to prevent overloads. The Dual Recording mode captures a copy of the audio at a lower level, so if there is distortion you have a backup safety. Recording can begin instantly by holding the record side switch while turning the unit on.
For simple-to-use ENG recording that stays out of the way, TASCAM’s DR-10X leads the field.
Mic shown in photo is not included with DR-10X
This recorder can be attached to a dynamic mic or a battery-powered condenser mic and record its output
This audio recorder is designed for plug-on connection, so it can be connected directly to XLR handheld mics. In addition to dynamic mics, it can also be used with battery-powered condenser mics. In addition to using this recorder with handheld mics in interviews and mics on stands in press conferences, it can also be used for recording seminars, meetings and any other situations using a handheld microphone.
Compact and lightweight
The DR-10X is compact - fitting in the palm of the hand and lightweight at 56.3 grams. In addition, the mic connector has a locking mechanism that ensures a tight fit to the microphone body giving the entire assembly a solid feel.When recording interviews or reporting that requires high audio quality, a field recorder is normally needed. But for small-scale reporting, you can record high-quality audio with just a microphone and the DR-10X. No need to carry bulky equipment - you can now record with a compact rig that you can hold in one hand.
Linear PCM Recorder with high-quality audio
|The recording switch uses a sliding mechanism. This prevents misoperation from accidentally pressing a button. In addition, the hold function can prevent recording from being stopped by accidental contact with a button. Since the DR-10X is designed to be used together with a mic as a single unit, it is engineered to prevent misoperation during recording.|
|You can check the battery level on the easy-to-read organic EL display.
Even if the battery should run out unexpectantly, the unit will automatically close the file to prevent the loss of already recorded data before it shuts down.
|Even though this unit is compact, it can play back recorded files. You can also connect headphones to check recorded data right away and to monitor the input during recording.|
|Recording Media||microSD card (64 MB to 2 GB),
microSDHC card (4 to 32 GB)
|SD Card Slot||Push-Push type (Guard cover mounted)|
|Recording Format||WAV (BWF)|
|Sampling Frequency||48 kHz|
|Analog Audio Input||XLR-3-31|
|Input Impedance||10 kOhms or more|
|Mic Input||Mic Input Gain: Low, Mid, High|
|Headphones||1/8" (3.5 mm) stereo mini jack (dual mono operation)|
|USB||Connector: Micro-B type (4 pin)
Maximum Output: USB 2.0 high speed mass storage
|Power||1x AAA battery (alkaline or NiMH)
USB bus power
|Battery Operating Time||Alkaline Battery (EVOLTA): About 10 hours|
|RTC||RTC Battery: 1x lithium (soldered in)|
|Dimensions (WxHxD)||52 x 94.4 x 28 mm|
|Weight||56.3 g without batteries|