ASHLY SRA 2075

SKU : SRA-2075

SGD 1,092.00
Availability: In stock

Power Amplifier, 2 x 75W @ 2-OHMs

Add To Wishlist

QTY

SHARE THIS PRODUCT:

The Ashly SRA-2075 is a 2-channel convection-cooled rackmount P.A. or studio power amplifier housed in a rugged 1RU metal chassis, offering an output of 40 Watts per side at 8 Ohms, designed to drive 4 and 8 Ohm loads.

 

The SRA-2075 incorporates a switch-mode-power supply and Class-D amplifier circuitry, providing a power-efficient solution. The low-noise unit features a switchable HPF filter and selectable gain sensitivity, turn-on delay DIP switches with up to 8 seconds of delay available, and dual or bridge modes of operation.

 

The SRA-2075 is equipped with a front-panel headphone monitoring output, an internally switchable 120V/240V power supply, extensive protection circuitry, and standard Euroblock inputs along with screw terminal outputs.

 

Features:

 

  • 1RU 9 lb. lightweight rackmount stereo power amplifier with 40 Watts per side power output at 8 Ohms
  • Selectable Dual or Bridge Mono Operation, designed for 4- or 8-Ohm loads
  • 2-stage high-efficiency switched mode power supply with high power-to-weight ratio
  • Ultra-quiet convection-cooled operation
  • On-board 80Hz HPF, selectable gain sensitivity
  • Up to 8 sec. of turn-on delay with selectable Dip Switch complement
  • Comprehensive amplifier protection circuitry includes: Output Over-current, DC Output, Main Supply Rail Over-voltage, Chassis Temperature, Inrush Limiting, Mains Fuse
  • Front Panel Indicators include: overall power, standby, and protect; per-channel clip and signal indicators
  • Euroblock input connectors, Screw Terminal outputs
Power Rating

Stereo @ 8 Ohms: 40W per Ch.


Stereo @ 4 Ohms: 75W per Ch.


Mono Bridge @ 8 Ohms: 150W

Damping Factor >200, 8-Ohm load, <1kHz
Input Sensitivity 1.5V
Input Impedance 20 kOhms, Balanced
Gain Selectable 26dB or 36dB
Frequency Response 20 Hz - 20 kHz, +/-1.0dB
Signal-to-Noise Ratio >98dB, 20Hz - 20kHz unweighted
Total Harmonic Distortion (THD) <0.01% (8-Ohm load, 10dB below rated power, 20Hz - 10kHz
Input Connections 2 x Ch.1,2 3- Pin Euroblock
Output Connectors

2 x Ch.1,2 Screw Terminals


1 x 1/4" Stereo Headphone Jack

Controls Front Panel

1 Power Switch


2 x Gain Control Knobs

Controls (Rear)

4 x Delay DIP Switches


2 x 80Hz HPF On/Off Button


2 x Gain Sensitivity Button


2 x Bridge/Stereo Mode Switch

Indicators

1 x Blue Power On LED


1 x Yellow Standby LED


1 x Red Protect LED


2 x Red Clip LED's


2 x Green Signal LED's

Cooling Convection-cooled
Power Consumption

18.75W (1/8 Power Pink Noise @ 4 Ohm)


Typical Current:


Idle: 0.30A


1/8 Power: 0.69A

Dimensions 19 x 1.75 x 11" (483 x 44.5 x 279.4mm)
Weight 9 lb (4.1 kg)
Specialties

Adjustable Turn-On delay Switches


Convection Cooling


Switch-Mode Power Supply

 

Click here for full specs